The height of the chimney relative to the ridge of the roof: the rules of calculating, parameters and requirements

Date:

2018-03-18 12:41:08

Views:

595

Rating:

1Like 0Dislike

Share:

Table of contents:

During the construction of the premises, equipped with a fireplace, stove or other heating devices with the supply of solid fuel, it is important to give sufficient attention to the fume paths. The height of the chimney relative to the ridge of the roof should comply with established norms for normal waste products of combustion.

What affects the height of the pipe?

The height of the chimney relative to the ridge of the roof depends not only on the type of the roof itself, but also from a number of other important settings:

  • The portion of the roof on which the chimney is located;
  • The angle of the roof slope;
  • Climate of the region where there is a structure, the amount and intensity of rainfall;
  • Buildings and green spaces around the building.

These data are taken into account when performing calculations to determine the height of the chimney relative to the ridge of the roof.

height of the chimney relative to the ridge of the roof

Optimum value

Before construction works it is important to determine the exact value of future fume paths. Builders are based on the following requirements for the erection of the chimney.

  1. If it is at a distance of 1.5 m from the ridge, the height over the highest point of the roof shall be not less than 0.5 m. Similar conditions locations provide good traction, but also limits the accumulation of snow in this area of the roof.
  2. When deleting from the highest point of the roof is 3 m, the height of the chimney relative to the ridge of the roof may be equal to the horizon. This means that it coincides with the height of the ridge or slightly exceeds it.
  3. When the location from the ridge at a distance of more than 3 m, the height should be 10 degrees below the horizon.

height of the chimney relative to the ridge of the roof SNiP

Recommended

The most effective methods of seed germination

The most effective methods of seed germination

Despite the fact that the method of seedling in vegetable production is a very time consuming process, it is used by most gardeners. Planting seeds in open ground is an easy and convenient method, but it is effective only in certain climatic zones. I...

Retro-reflective paint. The scope of

Retro-reflective paint. The scope of

When the vehicle began to fill the road, their popularity began to gain reflective paint. Thanks to this paint, as drivers and pedestrians becomes much easier to avoid accidents in the dark. Purpose paint Reflective paint – paint material, whic...

How to make icon with your own hands - options izgotovleniya (simple and complex)

How to make icon with your own hands - options izgotovleniya (simple and complex)

In Soviet times, many collecting badges, emblems, pennants. To get them was not easy. And today, thanks to technology, you can make them yourself. Knowing how to make icon with your own hands, and you can make original gifts to your friends, and make...

How to calculate the distance from the chimney to the roof ridge? It is important to schematically represent the layout of the roof, note the location of the fume paths. Using the geometric method, you have reduced the scale to multiply the height. The deviations noted with a ruler and draw the line.

If the house is situated among tall buildings or trees, the height of the chimney relative to the ridge of the roof at 45 degrees to be more relative to the highest point of the roof. Simply put, the chimney must rise above the ridge of 0.75 m.

height of the flue pipe relative to the ridge

The chimney and the heating functionality

According to SNiP, the height of the chimney relative to the ridge of the roof should be calculated correctly to ensure the normal waste of the smoke. In this case, will create air turbulence, which helps to bring flue gases from the system. From a good thrust directly depends on for proper operation of the heater. The thirst helps to effectively remove harmful substances from the home. It is directly connected with:

  • Height of the chimney relative to the ridge of the roof in the country;
  • Temperature difference inside and outside the tube;
  • The correctness of the inner section. So, for example too wide fireplace creates air currents, which not only derive gases, but also contribute to the appearance of the selling process;
  • The design of the chimney, namely, the number of turns of the tube;
  • Atmospheric pressure, excessive humidity, which may reduce traction.

To Determine the functionality of a fireplace without kindling the stove. It's enough to light a match or piece of paper, and hold it to the furnace. With good traction the flame will start to tighten inside, or it may even die.

height of chimney above the ridge of the roof calculation

Potential problems

Often before starting a new heating season, the owners of private houses are faced with such a problem when all the smoke begins to emit into the room. This may be due to the following factors:

  • Hit bird inner part of the tube;
  • Large accumulation of soot;
  • Collapse the pipe.

If you want to avoid this, before starting the furnace you need to check the furnace and fume collection path, to clean the tube from soot and carbon deposits.how to calculate the distance from the chimney to the ridge

How to be a fireplace?

It is Important to not only focus on calculations of the height of the chimney above the roof ridge, but also on its volume and shape. Best option considered round pipes, as they are not formed, the additional air turbulence, which prevent the passage of smoke. Besides, compared with square tubes, they do not have corners which can accumulate large amount of soot and fumes.

Top of the pipe must be secured with additional bracing to ensure stability. The top cover is usually set, which ensures the absence of contact inside the system foreign objects and precipitation.

Important points in the calculation of the chimney

The Parameters and calculations height of the chimney above the roof should be as correct to ensure comfortable use of the heater. It is important to consider the following points:

  • The choice of material for the manufacture of flue should occur based on the selected fuel for the furnace, as different species have different combustion temperature, and accordingly, the temperature of the smoke;
  • Ensuring adequate ventilation for waste gases emitted. Most often, the equipment is combined in one fume collection tube;
  • Design features of the building and the distance from the ridge.

The Heating devices with the supply of solid fuel, have a greater fire hazard, so if you previously had no experience in the calculation of the height of the chimney, you should use the online calculator or to entrust it to professionals.

height of the chimney relative to the ridge of the roof on the cottage

The dependence of the height of the section

How to calculate the height of the chimney above the ridge of the roof, given the cross-sectional shape of the pipe? Rules are governed by the SNP document, which includes the permissible characteristics of heating devices and fume paths. Recommended before starting the calculations to explore these provisions.

Released in combustion gases and smoke, have high temperature and moving up. To ensure good traction, the gases should have a low temperature, and the distance from the furnace to the outlet to be small. However, it is not always the case. The best option is a small section of pipe in combination with a large height. Thus, it is possible to increase the traction. If it is too large, then the heating capacity of the furnace will be reduced and, moreover, will need much more fuel. To avoid this, it is important to take into account all the parameters of the building, its location, the heating device and pipes.

how to calculate the height of chimneys above the ridge

Materials for building a chimney

The Initial requirements for the materials used for the construction of fume collection path is the way of fire safety, and inexpensive cost. There are the following acceptable materials:

  1. Brick is durable and safe, but has high cost and the tendency to soot accumulation.
  2. Asbestos cement unlike bricks - cheap, lightweight and easy to install. However, these chimneys are categorically not suitable for furnaces, a furnace which will substances having high burning temperature.
  3. Stainless steel quickly and easily installed, resistant to corrosion, has a low weight and cost. However, when choosing should be considered that stainless steel has thermal insulation properties, rapidly cooled, requires additional insulation at points of contact with bystrovozvodimye materials.
  4. Double-circuit design of steel has the following advantages: high speed of passage of the smoke through the system, it does not form a condensate, easy to install.
  5. Ceramic chimneys appeared on the market of building materials is relatively recent. They have the characteristics of: integrity designs, a circular cross section and perfectly smooth inside, allowing unimpeded passage of smoke, long service life, resistance to temperature changes and natural precipitation. Besides, such designs are protected by insulation from non-combustible building materials, have a protective box. The only obstacle to the installation may be high cost of this design.

The Chimney has a significant impact on the normal operation of the whole heating system, it is therefore of particular importance relate to the design and installation, as well as to keep in operation.

...

Article in other languages:

BE: https://www.tostpost.com/be/hatn-tul-nasc/25007-vyshynya-kom-na-adnosna-kan-ka-dahu-asabl-vasc-razl-ku-parametry-patra.html

DE: https://www.tostpost.com/de/gem-tlichkeit/25027-h-he-des-schornsteins-bez-glich-des-dachfirstes-besonderheiten-der-ber.html

ES: https://www.tostpost.com/es/la-comodidad-del-hogar/25049-la-altura-de-la-chimenea-sobre-la-cumbrera-del-tejado-caracter-sticas-.html

KK: https://www.tostpost.com/kk/domashniy-uyut/24988-bi-kt-g-m-rzhany-atysty-kerek-shatyryn-esepteu-erekshel-kter-parametrl.html

PL: https://www.tostpost.com/pl/komfort-domu/24918-wysoko-komina-wzgl-dem-kalenicy-dachu-cechy-oblicze-parametry-i-wymaga.html

PT: https://www.tostpost.com/pt/o-aconchego-do-lar/24928-a-altura-da-chamin-relativamente-skate-do-telhado-caracter-sticas-de-c.html

TR: https://www.tostpost.com/tr/domashniy-uyut/24995-baca-y-ksekli-i-nispeten-at-n-n-zellikleri-hesaplama-parametreleri-ve-.html

UK: https://www.tostpost.com/uk/domashn-y-zatishok/24974-visota-dimarya-schodo-konika-dahu-osoblivost-rozrahunku-parametri-vimo.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

What are the cutters for a router on wood

What are the cutters for a router on wood

Those who started to make a living at this woodworking craft relatively recently, I can hardly imagine how a couple of decades ago, the professionals managed to do without these handy tools. But today, cutters for a router on wood...

Installation of the pump in the heating system of the house. How to install a circulating pump?

Installation of the pump in the heating system of the house. How to install a circulating pump?

Private dwellings – today, it is not uncommon. It ceased to be something exceptional – to build on the site a good, solid house. Gone are all sorts of sheds and outhouses, but with them gone, and simplicity in construc...

Acrylic liner in the bathroom: reviews and tips

Acrylic liner in the bathroom: reviews and tips

This method of recovery bath as the installation of acrylic liner, used in Europe for a long time, now it is gaining popularity in our country. The experts especially recommend this method if it is not possible to make a complete ...

With bevelled glass: types and characteristics

With bevelled glass: types and characteristics

with bevelled Glass is distinguished by the presence on the edges of the processing at any angle up to 45 degrees. Mirror this effect is bright and festive, as the light at the edges shimmers and glitters.What is a facet?glassware...

Pawpaw lobed: description and photos

Pawpaw lobed: description and photos

the Family considered as over 2,000 species of plants. Many of them are economically valuable — give tasty fruit or aromatic oils. Grow all considered as in the tropics, as absolutely can not tolerate frost. The only excepti...

Boiler Ferroli: manual, specifications, reviews

Boiler Ferroli: manual, specifications, reviews

in order to provide your house with hot water and heat, you should use special equipment. In each case, you make the selection models, with an emphasis on power and performance. As the most optimal variant is the Ferroli boiler, w...