The starter is spinning but not spinning the engine. Why is the starter scrolls

Date:

2018-05-24 19:00:37

Views:

850

Rating:

1Like 0Dislike

Share:

Table of contents:

What to do if the starter is spinning but not spinning the engine, not it cranks the crankshaft? The reasons for this behavior, they should further study and consider methods of eliminating. It is possible that you will immediately start to panic, but should not do it. Repairs will cost a maximum of 300 rubles. The only thing that will take this failure – this time. But it all depends on what kind of fault disappeared in the starter. First you need to diagnose.

Diagnosing breakdown

the starter is spinning but not spinning the engine

So, the symptoms are obvious – the starter is spinning but not spinning the engine. Of course, you can start with the tow vehicle, but it is reasonable to do only if you want to get to the place of repair. Constantly thus to start the engine will not. The first thing to note, do you hear extraneous metallic sounds from the starter. If present, the cause of failure can be identified – the teeth on the flywheel ring faded, so the Bendix gear is not with them may engage.

But there may be other faults. For example, a breakdown of the Bendix. The main part – the overrunning clutch. With its help, the gear can rotate only in one direction. If it rotates freely in both directions, the overrunning clutch is damaged. Only have the Bendix replaced and this procedure will take maybe half an hour of time. Very rarely destroyed a metal plate or a plastic fork. If there is such a failure, the starter turns but will not start the engine because the pull-in relay closes the contacts, but does not engage gears.

Recommended

"IZH 350 Planeta Sport" – frisky Soviet bike

It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...

How does the rear bushing front arm and how many it serves?

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How to remove starter

repair of starter motors

You will need a small set of tools – keys 10 and 13. Regardless of what kind of car are removed this mechanism. Repair of starters for different brands and models of cars is carried out on one technology. The reason for that – identical design of the drive. They can vary in size, type (with gear or without) and shoes (plastic, metal plate). The rest of the differences are practically not observed.

However, on some models of cars have to Dodge not weak to remove the starter. For example, in the domestic classics to Unscrew the bottom nut, you need to get under the car to free the starter motor. And then using the head 13, a pair of universal joints and extension, remove this ill-fated gadget. However, most drivers simply ignore it, during Assembly, hold the fasteners on the two nuts. In the other models of domestic automobiles no problems with dismantling the starter is not observed.

How to replace the Bendix

starter turns but will not start

To Replace the Bendix, you can literally 10-15 minutes. With the proviso that the starter is already removed from the car and trained to conduct repair. First, twist the fasteners back cover, then remove rotor snap ring. Unscrew the two nuts that are tightened parts of the starter. But we can reconnect only after the brush unit will be disconnected stator windings. When doing repairs starters, try to pay attention to all the details, even the small ones.

First, clean up the slats and the housing. Second-rate the wear on the bushings and brushes. When disconnect all of the starter, the rotor will remain in the front cover. Closer to the edge is a retaining ring. On top of him wearing the clip, which you can shift in the direction of the rotor winding, causing a few light strokes. Then using a screwdriver, remove the ring. That's it, now the Bendix can easily be dismantled, and in its place install a new one. It is recommended that the spiral splines on the rotor surface to cover with petroleum jelly or graphite grease.

How to remove the box speeds

starter price

But it is much worse if the starter is spinning but not spinning the engine and heard a metal sound. This suggests that you will need to remove the gearbox to change the flywheel ring. If you're going here to climb, remember how long ago they changed the clutch. If you do not remember when, then purchase a kit – CD, basket, bearing and six bolts. The procedure for removing the gearbox is difficult, therefore once again it is expensive to carry out. First, disconnect all wires going to transmission and cable drive speedometer. Now drain the oil, simultaneously controlling its appearance.

After that disconnect the drives-remove inner CV joints from the transaxle. Please note that both hinge cannot be removed! First disassemble first, then in its place put the plug. Then just remove the second one. Otherwise, the differential will collapse, you will have to disassemble the box to eliminate breakage. Then hang the engine and transaxle, remove the pillows. However, this training is over. Now just Unscrew the bolts or the nuts that held the mount box to the motor. And you can do the undocking.

Replacement of flywheel ring gear

starter motor

Note that ifthe starter is spinning but not spinning the engine, and the reason is in the crown, his teeth are not all going to be destroyed. Most will be in perfect condition, but the small sector will be spoiled. The fact is that the crankshaft relative to the starter stops in one position. And it starts the engagement – kick the Bendix gear on the crown.

Repair of a crown can be completely free. It would be wiser to remove and install the opposite side. This item is completely symmetrical, so no problems will arise. New has cost about 200-250 rubles, which is also not hit the pocket. First, it needs to knock off the flywheel. Then the crown (new or same) warms up. Red hot is not necessary. And just applied to the flywheel. That's it, now the metal has cooled and the crown firmly clamps the flywheel. This can be a repair to be completed and to start assembling the car.

Conclusion

Now you know how easy it is to change the starter. The price of a new relatively small. For example, for automobiles of minimum 2,300 rubles. Of course, the more expensive the car, the more money will be spent on the purchase of the starter. But to change it completely is not always reasonable. If a fault in the Bendix, its cost is ten times lower. Therefore, it is easier to replace just this node.


Article in other languages:

AR: https://www.tostpost.com/ar/cars/628-the-starter-is-spinning-but-not-spinning-the-engine-why-is-the-starter.html

BE: https://www.tostpost.com/be/a-tamab-l/1066-startar-kruc-cca-ale-ne-kruc-c-ruhav-k-chamu-startar-prakruchvaecca.html

DE: https://www.tostpost.com/de/autos/1063-anlasser-dreht-aber-dreht-nicht-den-motor-warum-starter-gescrollt.html

ES: https://www.tostpost.com/es/coches/1068-el-motor-de-arranque-gira-pero-no-gira-el-motor-por-qu-el-motor-de-arr.html

HI: https://www.tostpost.com/hi/cars/628-the-starter-is-spinning-but-not-spinning-the-engine-why-is-the-starter.html

JA: https://www.tostpost.com/ja/cars/627-the-starter-is-spinning-but-not-spinning-the-engine-why-is-the-starter.html

KK: https://www.tostpost.com/kk/avtomobil-der/1066-starter-zymyrap-aynala-b-ra-krutit-oz-alt-ysh-nel-kten-starter-aynalad.html

PL: https://www.tostpost.com/pl/samochody/1069-rozrusznik-kr-ci-ale-nie-kr-ci-silnik-dlaczego-rozrusznik-przewija.html

PT: https://www.tostpost.com/pt/carros/1066-o-acionador-de-partida-gira-mas-n-o-torce-o-motor-por-que-o-acionador-.html

TR: https://www.tostpost.com/tr/arabalar/1072-mar-d-n-yor-ama-katlanm-bir-motor-neden-mar-kayar.html

UK: https://www.tostpost.com/uk/avtomob-l/1068-starter-krutit-sya-ale-ne-krutit-dvigun-chomu-starter-prokruchu-t-sya.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

Scooter Honda Dio AF 18: specifications, tuning

Scooter Honda Dio AF 18: specifications, tuning

the First model of scooter Honda Dio AF 18 from the Japanese manufacturer with a world name first appeared in the mid-nineties of the last century. Originally it was a modification, equipped with brake unit drum. Then there were t...

Motor oil

Motor oil "Kiks": description, technical specifications and reviews

Motor oil ensures the normal functioning of the mechanisms of the engine. From the correctness of his choice depends on the duration of the entire Assembly. The lubricant must have a certain set of qualities. This allows to provid...

List of Japanese brands of cars (photos)

List of Japanese brands of cars (photos)

Japan is often ahead of other countries in matters of technological progress, not least in terms of the automotive industry. Therefore, the list of Japanese brands of cars are known to many connoisseurs of quality vehicles –...

KamAZ-5320, PSU: the device and principle of work

KamAZ-5320, PSU: the device and principle of work

What is the device PGU of KAMAZ-5320? This question interests many beginners. This abbreviation may cause confusion in an ignorant person. In fact, PSU – pneumatic-hydraulic power steering. Consider the features of this devi...

How to sell a car. And some advice from a seasoned driver

How to sell a car. And some advice from a seasoned driver

Buying and selling cars is serious business, and you handle it accordingly. Need to renew a lot of different documents and perform a number of procedures. Is it possible to understand all these subtleties? One friend told abo...

For what the car uses glass door closer?

For what the car uses glass door closer?

Electronic door closer car Windows – it is a special electronic mechanism that automatically closes the window when the buttons are pressed the key FOB. The use of such devices allows to significantly facilitate the life of ...