In the modern technological world repair of various components and assemblies is becoming increasingly popular. The engine bulkhead is a complex process, which, in addition to skill, requires a good theoretical training. To quickly and effectively to eliminate breakage, it is necessary to conduct a thorough analysis and assessment of the unit, and here, of course, can not do without a diagnosis.
It is the first step before you start the engine bulkhead. Its price is low, it depends on the brand of your car. The whole procedure is carried out using a special scanner that connects to the onboard computer of a car and allows you to see not only General characteristics, but also the errors that arise in the process of operation of the engine. Only after that establish the specific cause of the failure, and starts the engine bulkhead. However, it should be noted that this diagnosis does not show small defects or future breakage. Bulkhead of the engine of VAZ models rarely includes diagnosis, on-Board computer, some of them completely absent. In this case, a full disassembly of the unit, and then detects and repairs any defective part, about which an entry in a special document.
Standard diagnostics before you start the engine bulkhead, includes:
- Measurement of compression in each cylinder;
- Examines the testimony of the exhaust gases and technical liquids;
- Checks the General technical condition of all components, parts and assemblies of the car;
- Determines the level of pressure in the cooling system, lubrication;
- checks for the presence of extraneous sounds.
After holding.Astiki the estimate on parts and installation. If the client agrees, then starts the engine bulkhead. It is important to note that every detail included in the estimate should discuss with the client should explain the appropriateness of this substitution and obtain customer permission for this operation. Full cycle from acceptance car to the service station prior to the issuance to the owner of professionals takes 3 to 5 days. Of course, there are times when the cost of the work and the amount of detail increases with a full disassembly. It is normal practice, because some machines are not so computerized to show the failure of some small parts or excessive wear. Be aware that in this case you must also inform before starting repairs, the cost of voice parts and labor. If the bill for the engine bulkhead was above the previously reported value, then you may require evidence of the feasibility of these actions, as well as providing old parts that were replaced.
Never skimp on this repair, choose proven and specialized centers. Overpaid 10-15% you will receive not only efficient service, but also will significantly increase the engine life of your car and will not rise again for repairs a few thousand miles.
Article in other languages:
Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."
Any experienced driver is able to take care of your vehicle and can even make some simple repairs. To change the consumables, replace suspension parts and so on. The only thing which is not necessary to climb, so it is in the engi...
From the article, you will learn how to change a heater radiator for VAZ 2109. This procedure is not very complicated but will require patience and some knowledge. As you know, heating of the cabin is connected to the cooling syst...
Mud on the road is present not only in autumn and spring, but in summer and winter. Behind cars on the highway stretches a long dark plume, instantly addictive film of dirt going behind the windshield of the car. The wipers and wa...
“Mercedes G-wagon" produced for 36 years and therefore is considered to be a German veteran. But no one in the head does not come to consign it to oblivion, because the demand for it is stable. And he was conceived as t...
One of the most popular currently the car «Kia» (country of origin-Korea) for the past 13 years of happy motorists. Model "Sorento" debuted in 2002 in America. After the presentation, in car dealerships Chica...
About the work of CVT company Jatco, a lot of rumors. Someone got lucky with buying a car, and someone after a few tens of thousands forced to change the box under warranty. What affects the endurance of this node? What is actuall...